Mts SWIFT 20 Ultra Sensor Bedienungsanleitung PDF herunterladen (Seite 43)

Low-Profile Transducer Interface

SWIFT 20 Sensors Hardware Overview

Low-Profile TI Jumpers

The transducer interface uses circuit board jumpers to establish certain

parameters and make use of various electronic functions. These jumpers are set at

the factory, and should not be reset. The following table is for reference only.

Low-Profile TI PWB Jumper Locations

Jumper Setting Function

1–2

2–3

Excitation setup for shunts FX1, FY1, FY4, and FZ2.

Sets up – (minus) excitation for shunts FX1, FY1, FY4, and FZ2.

Sets up + (plus) excitation for shunts FX1, FY1, FY4, and FZ2.

1–2

2–3

Excitation setup for shunts FX2, FY2, FY43 and FZ1.

Sets up – (minus) excitation for shunts FX2, FY2, FY43 and FZ1.

Sets up + (plus) excitation for shunts FX2, FY2, FY43 and FZ1.

X4 removed

Not used for Low-Profile TI applications (Standard setting).

X5 installed

removed

Enables the ability to download new code to the block of FLASH RAM

where the boot code is stored.

Disables the ability to download new code to the block of FLASH RAM

where the boot code is stored (Standard setting).

X6 installed

removed

Boots to the FLASH memory down-loader.

Boots to the Transducer Interface software (Standard setting).

S20-13

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 175 176

Keine Kommentare

Mts SWIFT 20 Ultra Sensor Bedienungsanleitung Seite 43