Mts 709 Alignment System Bedienungsanleitung PDF herunterladen (Seite 32)

709 Alignment System

Software Installation

Installation

Software Installation

Software installation consists of installing several pieces of software:

• .Net Framework Installation

• 709 Alignment Software Installation

• National Instruments (NI) FieldPoint Installation

• Upgrading The Firmware Located On The FieldPoint FP-2000 Hardware

• TCPIP Configuration

• FieldPoint Configuration

• MTS Licensing Software Installation (New License)

• Updating MTS Licenses (Replacement License)

The software is supplied on two CDs: one containing the 709, .Net, and CVI

runtime software, and one containing the FieldPoint software.

Demo mode The 709 Alignment software can also run in a demonstration mode. If you will

only be running the software in the demo mode, only the procedures for the

“.Net Framework Installation” on page 33 and the “709 Alignment Software

Installation” on page 35 need to be performed. The remaining installation

procedures are not required.

Remove previous installations

Important When upgrading from previous versions to version 3.3.1 of the 709

Alignment software, all previous versions of 709 Alignment

software, .Net Framework, and FieldPoint must be removed.

1. Select Add/Remove Programs in the Control Panel:

Start > Settings > Control Panel > Add/Remove Programs

2. Select MTS 709 Alignment. Click Remove.

3. A dialog window appears asking you to confirm the removal; click Ye s.

4. When removal is complete, click Finish.

5. Repeat steps 1 through 4 for the Microsoft .Net Framework and the NI

FieldPoint applications.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 157 158

Keine Kommentare

Mts 709 Alignment System Bedienungsanleitung Seite 32