Mts SWIFT 10 MC Sensor Bedienungsanleitung PDF herunterladen (Seite 34)

SWIFT 10 MC Sensors

Interfacing with RPC

Hardware Overview

Interfacing with RPC

The SWIFT sensor is directly compatible with the MTS Remote Parameter

Control (RPC) simulation software. The SWIFT system produces outputs that

directly correspond to the uncoupled spindle forces that the MTS Model 329

Road Simulator applies to the vehicle. Traditional instrumentation techniques

provide coupled suspension loads data. Using the SWIFT sensor, the RPC

simulation software needs to apply less correction to obtain the road simulator

drive signals. Fewer iterations are required to recreate the measured loads.

You must ensure that the full scale value for your data recorder and the MTS

electronics match. MTS electronics are typically set at ±10 V full scale, while

some data recorders are ±5 V full scale.

The SWIFT sensor is calibrated for ±10 V full scale. To recompute the TI gains

for ±5 V full scale, a verification pass must be run or the calibration will not be

traceable. Upon special request, MTS can evaluate and may provide calibration

for ±5 V or other full scale voltages.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 143 144

Keine Kommentare

Mts SWIFT 10 MC Sensor Bedienungsanleitung Seite 34