Mts Multipurpose Elite Bedienungsanleitung PDF herunterladen (Seite 81)

Using normalized dimensions to define control modes

You can use any of these normalized dimensions to define a control mode in a station configuration. If you

do this, and then attempt to play out a profile that also uses a normalized dimension, MPE will treat it as a

standard dimension when you define a Profile activity.

Example

Suppose you create a station configuration that uses volts as a dimension for a volt control mode, which is

associated with a conditioner that is connected to a displacement sensor with a full-scale displacement of

±200 cm.

Next, you create a profile in which you select the volts dimension to define end levels.

Then you start MPE against the station configuration, add a Profile activity, and select the profile you have

created.

On the Channels panel, you select a profile channel, and note that volts is available in the Control Mode list,

and that the Level Multiplier control shows 100%.

In this scenario, if the first end-level values in the profile are 1 V and 9 V, they will be played out as 20 cm

and 180 cm. If you change the Level Multiplier value to 50%, MPE would play out these values as 10 cm

and 90 cm.

Multipurpose Elite Test Design Guide 81

6.0 Creating Advanced Tests

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 111 112

Keine Kommentare

Mts Multipurpose Elite Bedienungsanleitung Seite 81